Keysight Technologies InfiniiVision 3000T X Series - :CHANnel<n>:INVert

272 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
10 :CHANnel<n> Commands
:CHANnel<n>:INVert
(see page 1276)
Command Syntax
:CHANnel<n>:INVert <invert value>
<invert value> ::= {{1 | ON} | {0 | OFF}
<n> ::= 1 to (# analog channels) in NR1 format
The :CHANnel<n>:INVert command selects whether or not to invert the input
signal for the specified channel. The inversion may be 1 (ON/inverted) or 0
(OFF/not inverted).
Query Syntax
:CHANnel<n>:INVert?
The :CHANnel<n>:INVert? query returns the current state of the channel inversion.
Return Format
<invert value><NL>
<invert value> ::= {0 | 1}
See Also • "Introduction to :CHANnel<n> Commands" on page 267