Keysight Technologies InfiniiVision 3000T X Series User Manual

:SBUS<n> Commands 29
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 701
:SBUS<n>:MODE
(see page 1276)
Command Syntax
:SBUS<n>:MODE <mode>
<mode> ::= {A429 | FLEXray | CAN | I2S | IIC | LIN | M1553 | SENT
| SPI | UART}
The :SBUS<n>:MODE command determines the decode mode for the serial bus.
Query Syntax
:SBUS<n>:MODE?
The :SBUS<n>:MODE? query returns the current serial bus decode mode setting.
Return Format
<mode><NL>
<mode> ::= {A429 | FLEX | CAN | I2S | IIC | LIN | M1553 | SENT | SPI
| UART | NONE}
Errors • "-241, Hardware missing" on page 1235
See Also • "Introduction to :SBUS<n> Commands" on page 697
• ":SBUS<n>:A429 Commands" on page 702
• ":SBUS<n>:CAN Commands" on page 719
• ":SBUS<n>:FLEXray Commands" on page 748
• ":SBUS<n>:I2S Commands" on page 767
• ":SBUS<n>:IIC Commands" on page 786
• ":SBUS<n>:LIN Commands" on page 796
• ":SBUS<n>:M1553 Commands" on page 810
• ":SBUS<n>:SENT Commands" on page 817
• ":SBUS<n>:SPI Commands" on page 850
• ":SBUS<n>:UART Commands" on page 866
NOTE
This command is only valid when a serial decode option has been licensed.

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English