Keysight Technologies InfiniiVision 3000T X Series - :SAVE[:SETup[:STARt]]

:SAVE Commands 28
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 689
:SAVE[:SETup[:STARt]]
(see page 1276)
Command Syntax
:SAVE[:SETup[:STARt]] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :SAVE[:SETup[:STARt]] command saves an oscilloscope setup.
See Also • "Introduction to :SAVE Commands" on page 669
• ":SAVE:FILename" on page 672
• ":SAVE:PWD" on page 682
• ":RECall:SETup[:STARt]" on page 664
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".scp".