Keysight Technologies InfiniiVision 3000T X Series - :SEARch:SERial:CAN:SYMBolic:VALue

:SEARch Commands 30
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 935
:SEARch:SERial:CAN:SYMBolic:VALue
(see page 1276)
Command Syntax
:SEARch:SERial:CAN:SYMBolic:VALue <data>
<data> ::= value in NR3 format
The :SEARch:SERial:CAN:SYMBolic:VALue command specifies the signal value to
search for when CAN symbolic data has been loaded (recalled) into the
oscilloscope and the CAN serial search mode is set to MSIGnal.
Query Syntax
:SEARch:SERial:CAN:SYMBolic:VALue?
The :SEARch:SERial:CAN:SYMBolic:VALue? query returns the specified signal
value.
Return Format
<data><NL>
<data> ::= value in NR3 format
See Also • ":RECall:DBC[:STARt]" on page 660
• ":SEARch:SERial:CAN:MODE" on page 927
• ":SEARch:SERial:CAN:SYMBolic:MESSage" on page 933
• ":SEARch:SERial:CAN:SYMBolic:SIGNal" on page 934
NOTE
Encoded signal values are not supported in the remote interface (even though they can be
used in the front panel graphical interface).