Keysight Technologies InfiniiVision 3000T X Series User Manual

1146 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
35 :WGEN<w> Commands
:WGEN<w>:MODulation:FM:DEViation
(see page 1276)
Command Syntax
:WGEN<w>:MODulation:FM:DEViation <frequency>
<w> ::= 1 in NR1 format
<frequency> ::= frequency deviation in Hz in NR3 format
The :WGEN<w>:MODulation:FM:DEViation command specifies the frequency
deviation from the original carrier signal frequency.
When the modulating signal is at its maximum amplitude, the output frequency is
the carrier signal frequency plus the deviation amount, and when the modulating
signal is at its minimum amplitude, the output frequency is the carrier signal
frequency minus the deviation amount.
The frequency deviation cannot be greater than the original carrier signal
frequency.
Also, the sum of the original carrier signal frequency and the frequency deviation
must be less than or equal to the maximum frequency for the selected waveform
generator function plus 100 kHz.
Query Syntax
:WGEN<w>:MODulation:FM:DEViation?
The :WGEN<w>:MODulation:FM:DEViation? query returns the frequency deviation
setting.
Return Format
<frequency><NL>
<frequency> ::= frequency deviation in Hz in NR3 format
See Also • ":WGEN<w>:MODulation:AM:DEPTh" on page 1144
• ":WGEN<w>:MODulation:AM:FREQuency" on page 1145
• ":WGEN<w>:MODulation:FM:FREQuency" on page 1147
• ":WGEN<w>:MODulation:FSKey:FREQuency" on page 1148
• ":WGEN<w>:MODulation:FSKey:RATE" on page 1149
• ":WGEN<w>:MODulation:FUNCtion" on page 1150
• ":WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry" on page 1151
• ":WGEN<w>:MODulation:STATe" on page 1153
• ":WGEN<w>:MODulation:TYPE" on page 1154

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English