Keysight Technologies InfiniiVision 3000T X Series - :FUNCtion<m>:BUS:SLOPe

372 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
18 :FUNCtion<m> Commands
:FUNCtion<m>:BUS:SLOPe
(see page 1276)
Command Syntax
:FUNCtion<m>:BUS:SLOPe <slope>
<m> ::= 1 to (# math functions) in NR1 format
<slope> ::= {NEGative | POSitive | EITHer}
The :FUNCtion<m>:BUS:SLOPe command specifies the clock signal edge for the
Chart Logic Bus State operation.
Query Syntax
:FUNCtion<m>:BUS:SLOPe?
The :FUNCtion<m>:BUS:SLOPe query returns the clock edge setting.
Return Format
<slope><NL>
<slope> ::= {NEGative | POSitive | EITHer}
See Also • ":FUNCtion<m>:OPERation" on page 390