Keysight Technologies InfiniiVision 3000T X Series User Manual

:WAVeform Commands 34
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1117
:WAVeform:UNSigned
(see page 1276)
Command Syntax
:WAVeform:UNSigned <unsigned>
<unsigned> ::= {{0 | OFF} | {1 | ON}}
The :WAVeform:UNSigned command turns unsigned mode on or off for the
currently selected waveform. Use the WAVeform:UNSigned command to control
whether data values are sent as unsigned or signed integers. This command can
be used to match the instrument's internal data type to the data type used by the
programming language. This command has no effect if the data format is ASCii.
If :WAVeform:SOURce is set to POD1, POD2, BUS1, or BUS2,
WAVeform:UNSigned must be set to ON.
Query Syntax
:WAVeform:UNSigned?
The :WAVeform:UNSigned? query returns the status of unsigned mode for the
currently selected waveform.
Return Format
<unsigned><NL>
<unsigned> ::= {0 | 1}
See Also • "Introduction to :WAVeform Commands" on page 1091
• ":WAVeform:SOURce" on page 1111

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English