Keysight Technologies InfiniiVision 3000T X Series - :TRIGger:TRANsition:SLOPe

:TRIGger Commands 33
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1069
:TRIGger:TRANsition:SLOPe
(see page 1276)
Command Syntax
:TRIGger:TRANsition:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:TRANsition:SLOPe command specifies a POSitive rising edge or a
NEGative falling edge.
Query Syntax
:TRIGger:TRANsition:SLOPe?
The :TRIGger:TRANsition:SLOPe? query returns the current rise/fall time trigger
slope setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:MODE" on page 1016
• ":TRIGger:TRANsition:SOURce" on page 1070