Keysight Technologies InfiniiVision 3000T X Series - :WAVeform:XINCrement

:WAVeform Commands 34
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1119
:WAVeform:XINCrement
(see page 1276)
Query Syntax
:WAVeform:XINCrement?
The :WAVeform:XINCrement? query returns the x-increment value for the currently
specified source. This value is the time difference between consecutive data points
in seconds.
Return Format
<value><NL>
<value> ::= x-increment in the current preamble in 64-bit
floating point NR3 format
See Also • "Introduction to :WAVeform Commands" on page 1091
• ":WAVeform:PREamble" on page 1106
Example Code • "Example Code" on page 1107