Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:SENT:CRC

:SBUS<n> Commands 29
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 821
:SBUS<n>:SENT:CRC
(see page 1276)
Command Syntax
:SBUS<n>:SENT:CRC <format>
<format> ::= {LEGacy | RECommended}
The :SBUS<n>:SENT:CRC command specifies the format of the CRC. Either
Legacy (2008) or Recommended (2010).
Enhanced Serial Message CRCs are always calculated using the 2010 format, but
for the Fast Channel Messages, and for Short Serial Message CRCs, this setting is
used.
Query Syntax
:SBUS<n>:SENT:CRC?
The :SBUS<n>:SENT:CRC? query returns the CRC format setting.
Return Format
<format><NL>
<format> ::= {LEG | REC}
See Also • ":SBUS<n>:SENT:CLOCk" on page 820
• ":SBUS<n>:SENT:DISPlay" on page 822
• ":SBUS<n>:SENT:FORMat" on page 824
• ":SBUS<n>:SENT:IDLE" on page 826
• ":SBUS<n>:SENT:LENGth" on page 827
• ":SBUS<n>:SENT:PPULse" on page 828
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 829
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 830
• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 832
• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 833
• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 834
• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 836
• ":SBUS<n>:SENT:SOURce" on page 838
• ":SBUS<n>:SENT:TOLerance" on page 840
• ":SBUS<n>:SENT:TRIGger" on page 841
• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 843
• ":SBUS<n>:SENT:TRIGger:SLOW:DATA" on page 844
• ":SBUS<n>:SENT:TRIGger:SLOW:ID" on page 846
• ":SBUS<n>:SENT:TRIGger:SLOW:ILENgth" on page 848
• ":SBUS<n>:SENT:TRIGger:TOLerance" on page 849