:COUNter Commands 11
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 291
:COUNter:MODE
(see page 1276)
Command Syntax
:COUNter:MODE <mode>
<mode> ::= {FREQuency | PERiod | TOTalize}
The :COUNter:MODE command sets the counter mode:
• FREQuency — the cycles per second (Hz) of the signal.
• PERiod — the time periods of the signal's cycles.
• TOTalize — the count of edge events on the signal.
Query Syntax
:COUNter:MODE
The :COUNter:MODE? query returns the counter mode setting.
Return Format
<mode><NL>
<mode> ::= {FREQ | PER | TOT}
See Also • ":COUNter:CURRent" on page 289
• ":COUNter:ENABle" on page 290
• ":COUNter:NDIGits" on page 292
• ":COUNter:SOURce" on page 293
• ":COUNter:TOTalize:CLEar" on page 294
• ":COUNter:TOTalize:GATE:ENABle" on page 295
• ":COUNter:TOTalize:GATE:POLarity" on page 296
• ":COUNter:TOTalize:GATE:SOURce" on page 297
• ":COUNter:TOTalize:SLOPe" on page 298
To Next Page
Loading...
