Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:I2 S:TRIGger:PATTern:FORMat

:SBUS<n> Commands 29
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 781
:SBUS<n>:I2S:TRIGger:PATTern:FORMat
(see page 1276)
Command Syntax
:SBUS<n>:I2S:TRIGger:PATTern:FORMat <base>
<base> ::= {BINary | HEX | DECimal}
The :SBUS<n>:I2S:TRIGger:PATTern:FORMat command sets the entry (and query)
number base used by the :SBUS<n>:I2S:TRIGger:PATTern:DATA command. The
default <base> is DECimal.
Query Syntax
:SBUS<n>:I2S:TRIGger:PATTern:FORMat?
The :SBUS<n>:I2S:TRIGger:PATTern:FORMat? query returns the currently set
number base for I2S pattern data.
Return Format
<base><NL>
<base> ::= {BIN | HEX | DEC}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":SBUS<n>:I2S:TRIGger:AUDio" on page 778
• ":SBUS<n>:I2S:TRIGger" on page 776