Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:FLEXray:SOURce

:SBUS<n> Commands 29
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 757
:SBUS<n>:FLEXray:SOURce
(see page 1276)
Command Syntax
:SBUS<n>:FLEXray:SOURce <source>
<source> ::= {CHANnel<n>}
<n>::={1|2|3|4}
The :SBUS<n>:FLEXray:SOURce command specifies the input source for the
FlexRay signal.
Query Syntax
:SBUS<n>:FLEXray:SOURce?
The :SBUS<n>:FLEXray:SOURce? query returns the current source for the FlexRay
signal.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":SBUS<n>:FLEXray:TRIGger" on page 758
• ":SBUS<n>:FLEXray:TRIGger:EVENt:TYPE" on page 762
• ":SBUS<n>:FLEXray:AUTosetup" on page 750