616 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:ONOFf:NEXT
(see page 1276)
Command Syntax
:POWer:ONOFf:NEXT
The :POWer:ONOFf:NEXT command goes to the next step of the turn on/turn off
analysis.
This command is equivalent to pressing the Next softkey on the oscilloscope front
panel when prompted during the analysis.
See Also • ":POWer:ONOFf:APPLy" on page 614
• ":POWer:ONOFf:EXIT" on page 615
• ":POWer:ONOFf:TEST" on page 617
To Next Page
Loading...
