Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

:SBUS<n> Commands 29

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 881

:SBUS<n>:UART:TRIGger:BASE

(see page 1276)

Command Syntax

:SBUS<n>:UART:TRIGger:BASE <base>

<base> ::= {ASCii | HEX}

The :SBUS<n>:UART:TRIGger:BASE command sets the front panel UART/RS232

trigger setup data selection option:

• ASCii — front panel data selection is from ASCII values.

• HEX — front panel data selection is from hexadecimal values.

The :SBUS<n>:UART:TRIGger:BASE setting does not affect the

:SBUS<n>:UART:TRIGger:DATA command which can always set data values using

ASCII or hexadecimal values.

Query Syntax

:SBUS<n>:UART:TRIGger:BASE?

The :SBUS<n>:UART:TRIGger:BASE? query returns the current UART base setting.

Return Format

<base> ::= {ASC | HEX}

See Also • "Introduction to :TRIGger Commands" on page 1007

• ":TRIGger:MODE" on page 1016

• ":SBUS<n>:UART:TRIGger:DATA" on page 883

NOTE

The :SBUS<n>:UART:TRIGger:BASE command is independent of the :SBUS<n>:UART:BASE

command which affects decode and Lister only.

Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:UART:TRIGger:BASE