Keysight Technologies InfiniiVision 3000T X Series - :SAVE:LISTer[:STARt]

678 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
28 :SAVE Commands
:SAVE:LISTer[:STARt]
(see page 1276)
Command Syntax
:SAVE:LISTer[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:LISTer[:STARt] command saves the Lister display data to a file.
See Also • "Introduction to :SAVE Commands" on page 669
• ":SAVE:FILename" on page 672
• Chapter 20, “:LISTer Commands,” starting on page 421
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".csv".