Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

280 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

10 :CHANnel<n> Commands

:CHANnel<n>:PROBe:STYPe

(see page 1276)

Command Syntax

:CHANnel<n>:PROBe:STYPe <signal type>

<signal type> ::= {DIFFerential | SINGle}

<n> ::= 1 to (# analog channels) in NR1 format

The :CHANnel<n>:PROBe:STYPe command sets the channel probe signal type

(STYPe) to differential or single-ended when using the 113xA Series probes and

determines how offset is applied.

When single-ended is selected, the :CHANnel<n>:OFFSet command changes the

offset value of the probe amplifier. When differential is selected, the

:CHANnel<n>:OFFSet command changes the offset value of the channel amplifier.

Query Syntax

:CHANnel<n>:PROBe:STYPe?

The :CHANnel<n>:PROBe:STYPe? query returns the current probe signal type

setting for the selected channel.

Return Format

<signal type> ::= {DIFF | SING}

See Also • "Introduction to :CHANnel<n> Commands" on page 267

• ":CHANnel<n>:OFFSet" on page 274

NOTE

This command is valid only for the 113xA Series probes.

Keysight Technologies InfiniiVision 3000T X Series - :CHANnel<n>:PROBe:STYPe