To Next Page

To Previous Page

1150 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide

35 :WGEN<w> Commands

:WGEN<w>:MODulation:FUNCtion

(see page 1276)

Command Syntax

:WGEN<w>:MODulation:FUNCtion <shape>

<w> ::= 1 in NR1 format

<shape> ::= {SINusoid | SQUare| RAMP}

The :WGEN<w>:MODulation:FUNCtion command specifies the shape of the

modulating signal.

When the RAMP shape is selected, you can specify the amount of time per cycle

that the ramp waveform is rising with the

:WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry command.

This command applies to AM and FM modulation. (The FSK modulation signal is a

square wave shape.)

Query Syntax

:WGEN<w>:MODulation:FUNCtion?

The :WGEN<w>:MODulation:FUNCtion? query returns the specified modulating

signal shape.

Return Format

<shape> ::= {SIN | SQU| RAMP}

See Also • ":WGEN<w>:MODulation:AM:DEPTh" on page 1144

• ":WGEN<w>:MODulation:AM:FREQuency" on page 1145

• ":WGEN<w>:MODulation:FM:DEViation" on page 1146

• ":WGEN<w>:MODulation:FM:FREQuency" on page 1147

• ":WGEN<w>:MODulation:FSKey:FREQuency" on page 1148

• ":WGEN<w>:MODulation:FSKey:RATE" on page 1149

• ":WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry" on page 1151

• ":WGEN<w>:MODulation:STATe" on page 1153

• ":WGEN<w>:MODulation:TYPE" on page 1154

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: