Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:SENT:SIGNal<s>:MULTiplier

832 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:SENT:SIGNal<s>:MULTiplier
(see page 1276)
Command Syntax
:SBUS<n>:SENT:SIGNal<s>:MULTiplier <multiplier>
<s> ::= 1-6, in NR1 format.
<multiplier> ::= from 1-24, in NR3 format.
When the display mode setting is SYMBolic (see :SBUS<n>:SENT:DISPlay), the
:SBUS<n>:SENT:SIGNal<s>:MULTiplier command specifies the multiplier to be
used in calculating a physical value displayed for a Fast Channel Signal.
• PhysicalValue = (Multiplier * SignalValueAsUnsignedInteger) + Offset
Query Syntax
:SBUS<n>:SENT:SIGNal<s>:MULTiplier?
The :SBUS<n>:SENT:SIGNal<s>:MULTiplier? query returns the multiplier value for
the Fast Channel Signal.
Return Format
<multiplier><NL>
<multiplier> ::= from 1-24, in NR3 format.
See Also • ":SBUS<n>:SENT:CLOCk" on page 820
• ":SBUS<n>:SENT:CRC" on page 821
• ":SBUS<n>:SENT:DISPlay" on page 822
• ":SBUS<n>:SENT:FORMat" on page 824
• ":SBUS<n>:SENT:IDLE" on page 826
• ":SBUS<n>:SENT:LENGth" on page 827
• ":SBUS<n>:SENT:PPULse" on page 828
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 829
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 830
• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 833
• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 834
• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 836
• ":SBUS<n>:SENT:SOURce" on page 838
• ":SBUS<n>:SENT:TOLerance" on page 840
• ":SBUS<n>:SENT:TRIGger" on page 841
• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 843
• ":SBUS<n>:SENT:TRIGger:SLOW:DATA" on page 844
• ":SBUS<n>:SENT:TRIGger:SLOW:ID" on page 846
• ":SBUS<n>:SENT:TRIGger:SLOW:ILENgth" on page 848
• ":SBUS<n>:SENT:TRIGger:TOLerance" on page 849