Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:SENT:IDLE

826 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:SENT:IDLE
(see page 1276)
Command Syntax
:SBUS<n>:SENT:IDLE <state>
<state> ::= {LOW | HIGH}
The :SBUS<n>:SENT:IDLE command specifies the idle state of the SENT bus.
Query Syntax
:SBUS<n>:SENT:IDLE?
The :SBUS<n>:SENT:IDLE? query returns the idle state setting.
Return Format
<state><NL>
<state> ::= {LOW | HIGH}
See Also • ":SBUS<n>:SENT:CLOCk" on page 820
• ":SBUS<n>:SENT:CRC" on page 821
• ":SBUS<n>:SENT:DISPlay" on page 822
• ":SBUS<n>:SENT:FORMat" on page 824
• ":SBUS<n>:SENT:LENGth" on page 827
• ":SBUS<n>:SENT:PPULse" on page 828
• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 829
• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 830
• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 832
• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 833
• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 834
• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 836
• ":SBUS<n>:SENT:SOURce" on page 838
• ":SBUS<n>:SENT:TOLerance" on page 840
• ":SBUS<n>:SENT:TRIGger" on page 841
• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 843
• ":SBUS<n>:SENT:TRIGger:SLOW:DATA" on page 844
• ":SBUS<n>:SENT:TRIGger:SLOW:ID" on page 846
• ":SBUS<n>:SENT:TRIGger:SLOW:ILENgth" on page 848
• ":SBUS<n>:SENT:TRIGger:TOLerance" on page 849