Keysight Technologies InfiniiVision 3000T X Series - :SAVE:ARBitrary[:STARt]

:SAVE Commands 28
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 671
:SAVE:ARBitrary[:STARt]
(see page 1276)
Command Syntax
:SAVE:ARBitrary:[STARt] [<file_spec>][, <wavegen_id>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-3; an integer in NR1 format
<file_name> ::= quoted ASCII string
<wavegen_id> ::= WGEN1
The :SAVE:ARBitrary:[STARt] command saves the current arbitrary waveform to an
internal location or a file on a USB storage device.
The <wavegen_id> parameter specifies which waveform generator to save the
arbitrary waveform from.
See Also • "Introduction to :SAVE Commands" on page 669
• ":SAVE:FILename" on page 672
• ":SAVE:PWD" on page 682
• ":RECall:ARBitrary[:STARt]" on page 659
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".csv".