Keysight Technologies InfiniiVision 3000T X Series - :FFT:AVERage:COUNt

:FFT Commands 17
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 347
:FFT:AVERage:COUNt
(see page 1276)
Command Syntax
:FFT:AVERage:COUNt <count>
<count> ::= an integer from 2 to 65536 in NR1 format.
The :FFT:AVERage:COUNt command sets the number of waveforms to be
averaged together.
The number of averages can be set from 2 to 65536 in increments of powers of 2.
Increasing the number of averages will increase resolution and reduce noise.
Query Syntax
:FFT:AVERage:COUNt?
The :FFT:AVERage:COUNt? query returns the number of waveforms to be
averaged together.
Return Format
<count><NL>
<count> ::= an integer from 2 to 65536 in NR1 format.
See Also • ":FFT:CENTer" on page 348
• ":FFT:CLEar" on page 349
• ":FFT:DISPlay" on page 350
• ":FFT:DMODe" on page 351
• ":FFT:OFFSet" on page 353
• ":FFT:RANGe" on page 354
• ":FFT:REFerence" on page 355
• ":FFT:SCALe" on page 356
• ":FFT:SOURce1" on page 357
• ":FFT:SPAN" on page 358
• ":FFT:STARt" on page 359
• ":FFT:STOP" on page 360
• ":FFT:VTYPe" on page 361
• ":FFT:WINDow" on page 362