Keysight Technologies InfiniiVision 3000T X Series User Manual

:MTESt Commands 24
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 573
:MTESt:RMODe:SIGMa
(see page 1276)
Command Syntax
:MTESt:RMODe:SIGMa <level>
<level> ::= from 0.1 to 9.3 in NR3 format
When the :MTESt:RMODe command is set to SIGMa, the :MTESt:RMODe:SIGMa
command sets the test sigma level to which a mask test runs. Test sigma is the
best achievable process sigma, assuming no failures. (Process sigma is calculated
using the number of failures per test.) The test sigma level indirectly specifies the
number of waveforms that must be tested (in order to reach the sigma level).
Query Syntax
:MTESt:RMODe:SIGMa?
The :MTESt:RMODe:SIGMa? query returns the current Sigma level setting.
Return Format
<level><NL>
<level> ::= from 0.1 to 9.3 in NR3 format
See Also • "Introduction to :MTESt Commands" on page 551
• ":MTESt:RMODe" on page 568
Example Code • "Example Code" on page 551

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English