Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:CAN:TRIGger:SYMBolic:VALue

:SBUS<n> Commands 29
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 747
:SBUS<n>:CAN:TRIGger:SYMBolic:VALue
(see page 1276)
Command Syntax
:SBUS<n>:CAN:TRIGger:SYMBolic:VALue <data>
<data> ::= value in NR3 format
The :SBUS<n>:CAN:TRIGger:SYMBolic:VALue command specifies the signal value
to trigger on when CAN symbolic data has been loaded (recalled) into the
oscilloscope and the CAN trigger mode is set to MSIGnal.
Query Syntax
:SBUS<n>:CAN:TRIGger:SYMBolic:VALue?
The :SBUS<n>:CAN:TRIGger:SYMBolic:VALue? query returns the specified signal
value.
Return Format
<data><NL>
<data> ::= value in NR3 format
See Also • ":RECall:DBC[:STARt]" on page 660
• ":SBUS<n>:CAN:TRIGger" on page 735
• ":SBUS<n>:CAN:TRIGger:SYMBolic:MESSage" on page 745
• ":SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal" on page 746
NOTE
Encoded signal values are not supported in the remote interface (even though they can be
used in the front panel graphical interface).