Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:LIN:TRIGger

804 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:LIN:TRIGger
(see page 1276)
Command Syntax
:SBUS<n>:LIN:TRIGger <condition>
<condition> ::= {SYNCbreak | ID | DATA | PARityerror | CSUMerror}
The :SBUS<n>:LIN:TRIGger command sets the LIN trigger condition to be:
•SYNCbreak — Sync Break.
•ID — Frame ID.
Use the :SBUS<n>:LIN:TRIGger:ID command to specify the frame ID.
•DATA — Frame ID and Data.
Use the :SBUS<n>:LIN:TRIGger:ID command to specify the frame ID.
Use the :SBUS<n>:LIN:TRIGger:PATTern:DATA:LENGth and
:SBUS<n>:LIN:TRIGger:PATTern:DATA commands to specify the data string
length and value.
• PARityerror — parity errors.
• CSUMerror — checksum errors.
Query Syntax
:SBUS<n>:LIN:TRIGger?
The :SBUS<n>:LIN:TRIGger? query returns the current LIN trigger value.
Return Format
<condition><NL>
<condition> ::= {SYNC | ID | DATA | PAR | CSUM}
Errors • "-241, Hardware missing" on page 1235
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:MODE" on page 1016
• ":SBUS<n>:LIN:TRIGger:ID" on page 805
• ":SBUS<n>:LIN:TRIGger:PATTern:DATA:LENGth" on page 808
• ":SBUS<n>:LIN:TRIGger:PATTern:DATA" on page 806
• ":SBUS<n>:LIN:SIGNal:DEFinition" on page 1226
• ":SBUS<n>:LIN:SOURce" on page 801