Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:LIN:TRIGger:ID

:SBUS<n> Commands 29
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 805
:SBUS<n>:LIN:TRIGger:ID
(see page 1276)
Command Syntax
:SBUS<n>:LIN:TRIGger:ID <value>
<value> ::= 7-bit integer in decimal, <nondecimal>, or <string>
from 0-63 or 0x00-0x3f
<nondecimal> ::= #Hnn where n ::= {0,..,9 | A,..,F} for hexadecimal
<nondecimal> ::= #Bnn...n where n ::= {0 | 1} for binary
<string> ::= "0xnn" where n ::= {0,..,9 | A,..,F} for hexadecimal
The :SBUS<n>:LIN:TRIGger:ID command defines the LIN identifier searched for in
each CAN message when the LIN trigger mode is set to frame ID.
Setting the ID to a value of "-1" results in "0xXX" which is equivalent to all IDs.
Query Syntax
:SBUS<n>:LIN:TRIGger:ID?
The :SBUS<n>:LIN:TRIGger:ID? query returns the current LIN identifier setting.
Return Format
<value><NL>
<value> ::= integer in decimal
Errors • "-241, Hardware missing" on page 1235
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:MODE" on page 1016
• ":SBUS<n>:LIN:TRIGger" on page 804
• ":SBUS<n>:LIN:SIGNal:DEFinition" on page 1226
• ":SBUS<n>:LIN:SOURce" on page 801