Keysight Technologies InfiniiVision 3000T X Series - :WGEN<w>:OUTPut:POLarity

1158 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
35 :WGEN<w> Commands
:WGEN<w>:OUTPut:POLarity
(see page 1276)
Command Syntax
:WGEN<w>:OUTPut:POLarity <polarity>
<w> ::= 1 or 2 in NR1 format
<polarity> ::= {NORMal | INVerted}
The :WGEN<w>:OUTPut:POLarity command specifies whether the waveform
generator output is inverted..
Query Syntax
:WGEN<w>:OUTPut:POLarity?
The :WGEN<w>:OUTPut:POLarity? query returns the specified output polarity.
Return Format
<polarity><NL>
<polarity> ::= {NORM | INV}
See Also • "Introduction to :WGEN<w> Commands" on page 1128