Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:SPI:SOURce:CLOCk

856 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:SPI:SOURce:CLOCk
(see page 1276)
Command Syntax
:SBUS<n>:SPI:SOURce:CLOCk <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:SPI:SOURce:CLOCk command sets the source for the SPI serial
clock.
Query Syntax
:SBUS<n>:SPI:SOURce:CLOCk?
The :SBUS<n>:SPI:SOURce:CLOCk? query returns the current source for the SPI
serial clock.
Return Format
<source><NL>
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":SBUS<n>:SPI:CLOCk:SLOPe" on page 853
• ":SBUS<n>:SPI:CLOCk:TIMeout" on page 854
• ":SBUS<n>:SPI:SOURce:FRAMe" on page 857
• ":SBUS<n>:SPI:SOURce:MOSI" on page 859
• ":SBUS<n>:SPI:SOURce:MISO" on page 858