Keysight Technologies InfiniiVision 3000T X Series - :POWer:INRush:EXIT

:POWer Commands 26
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 609
:POWer:INRush:EXIT
(see page 1276)
Command Syntax
:POWer:INRush:EXIT
The :POWer:INRush:EXIT command exits (stops) the inrush current power analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope front
panel during the analysis.
See Also • ":POWer:INRush:APPLy" on page 608
• ":POWer:INRush:NEXT" on page 610