Keysight Technologies InfiniiVision 3000T X Series - :RECall:WMEMory<r>[:STARt]

:RECall Commands 27
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 665
:RECall:WMEMory<r>[:STARt]
(see page 1276)
Command Syntax
:RECall:WMEMory<r>[:STARt] [<file_name>]
<r> ::= 1 to (# ref waveforms) in NR1 format
<file_name> ::= quoted ASCII string
The :RECall:WMEMory<r>[:STARt] command recalls a reference waveform.
See Also • "Introduction to :RECall Commands" on page 658
• ":RECall:FILename" on page 661
• ":SAVE:WMEMory[:STARt]" on page 696
NOTE
If a file extension is provided as part of a specified <file_name>, it must be ".h5".