Keysight Technologies InfiniiVision 3000T X Series User Manual

236 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
7 :ACQuire Commands
:ACQuire:POINts
(see page 1276)
Query Syntax
:ACQuire:POINts?
The :ACQuire:POINts? query returns the number of data points that the hardware
will acquire from the input signal. The number of points acquired is not directly
controllable. To set the number of points to be transferred from the oscilloscope,
use the command :WAVeform:POINts. The :WAVeform:POINts? query will return
the number of points available to be transferred from the oscilloscope.
Return Format <points_argument><NL>
<points_argument> ::= an integer in NR1 format
See Also • "Introduction to :ACQuire Commands" on page 231
• ":DIGitize" on page 203
• ":WAVeform:POINts" on page 1102

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English