Keysight Technologies InfiniiVision 3000T X Series

To Next Page

To Previous Page

:MEASure Commands 22

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 511

:MEASure:VAMPlitude

(see page 1276)

Command Syntax

:MEASure:VAMPlitude [<source>]

<source> ::= {CHANnel<n> | FUNCtion<m> | MATH<m> | WMEMory<r>}

<n> ::= 1 to (# analog channels) in NR1 format

<m> ::= 1 to (# math functions) in NR1 format

<r> ::= 1 to (# ref waveforms) in NR1 format

The :MEASure:VAMPlitude command installs a screen measurement and starts a

vertical amplitude measurement. If the optional source parameter is specified, the

current source is modified.

Query Syntax

:MEASure:VAMPlitude? [<source>]

The :MEASure:VAMPlitude? query measures and returns the vertical amplitude of

the waveform. To determine the amplitude, the instrument measures Vtop and

Vbase, then calculates the amplitude as follows:

vertical amplitude = Vtop - Vbase

Return Format

<value> ::= the amplitude of the selected waveform in NR3 format

See Also • "Introduction to :MEASure Commands" on page 458

• ":MEASure:SOURce" on page 499

• ":MEASure:VBASe" on page 513

• ":MEASure:VTOP" on page 520

• ":MEASure:VPP" on page 516

Keysight Technologies InfiniiVision 3000T X Series - :MEASure:VAMPlitude