Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:LIN:STANdard

802 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:LIN:STANdard
(see page 1276)
Command Syntax
:SBUS<n>:LIN:STANdard <std>
<std> ::= {LIN13 | LIN20}
The :SBUS<n>:LIN:STANdard command sets the LIN standard in effect for
triggering and decoding to be LIN1.3 or LIN2.0.
Query Syntax
:SBUS<n>:LIN:STANdard?
The :SBUS<n>:LIN:STANdard? query returns the current LIN standard setting.
Return Format
<std><NL>
<std> ::= {LIN13 | LIN20}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:MODE" on page 1016
• ":SBUS<n>:LIN:SIGNal:DEFinition" on page 1226
• ":SBUS<n>:LIN:SOURce" on page 801