Keysight Technologies InfiniiVision 3000T X Series - :WMEMory<r>:DISPlay

1168 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
36 :WMEMory<r> Commands
:WMEMory<r>:DISPlay
(see page 1276)
Command Syntax
:WMEMory<r>:DISPlay <on_off>
<r> ::= 1 to (# ref waveforms) in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}}
The :WMEMory<r>:DISPlay command turns the display of the specified reference
waveform on or off.
There are two reference waveform locations, but only one reference waveform can
be displayed at a time. That means, if :WMEMory1:DISPlay is ON, sending the
:WMEMory2:DISPlay ON command will automatically set :WMEMory1:DISPlay
OFF.
Query Syntax
:WMEMory<r>:DISPlay?
The :WMEMory<r>:DISPlay? query returns the current display setting for the
reference waveform.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • Chapter 36, “:WMEMory<r> Commands,” starting on page 1165
• ":WMEMory<r>:CLEar" on page 1167
• ":WMEMory<r>:LABel" on page 1169