Keysight Technologies InfiniiVision 3000T X Series User Manual

:EXTernal Trigger Commands 16
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 343
:EXTernal:UNITs
(see page 1276)
Command Syntax
:EXTernal:UNITs <units>
<units> ::= {VOLT | AMPere}
The :EXTernal:UNITs command sets the measurement units for the probe
connected to the external trigger input. Select VOLT for a voltage probe and select
AMPere for a current probe. Measurement results, channel sensitivity, and trigger
level will reflect the measurement units you select.
Query Syntax
:EXTernal:UNITs?
The :CHANnel<n>:UNITs? query returns the current units setting for the external
trigger.
Return Format
<units><NL>
<units> ::= {VOLT | AMP}
See Also • "Introduction to :EXTernal Trigger Commands" on page 339
• "Introduction to :TRIGger Commands" on page 1007
• ":EXTernal:RANGe" on page 342
• ":EXTernal:PROBe" on page 341
• ":CHANnel<n>:UNITs" on page 284

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English