Keysight Technologies InfiniiVision 3000T X Series - :TRIGger:RUNT:TIME

1060 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
33 :TRIGger Commands
:TRIGger:RUNT:TIME
(see page 1276)
Command Syntax
:TRIGger:RUNT:TIME <time>[suffix]
<time> ::= floating-point number in NR3 format
[suffix] ::= {s | ms | us | ns | ps}
When triggering on runt pulses whose width is greater than or less than a certain
value (see :TRIGger:RUNT:QUALifier), the :TRIGger:RUNT:TIME command
specifies the time used with the qualifier.
Query Syntax
:TRIGger:RUNT:TIME?
The :TRIGger:RUNT:TIME? query returns the current runt pulse qualifier time
setting.
Return Format
<time><NL>
<time> ::= floating-point number in NR3 format
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:RUNT:QUALifier" on page 1058