Keysight Technologies InfiniiVision 3000T X Series User Manual

:MARKer Commands 21
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 439
:MARKer:YDELta
(see page 1276)
Query Syntax
:MARKer:YDELta?
The :MARKer:YDELta? query returns the value difference between the current Y1
and Y2 cursor positions.
Ydelta = (Value at Y2 cursor) - (Value at Y1 cursor)
Y cursor units are set by the :MARKer:YUNits command.
Return Format
<value><NL>
<value> ::= difference value in NR3 format
See Also • "Introduction to :MARKer Commands" on page 426
• ":MARKer:MODE" on page 429
• ":MARKer:X1Y1source" on page 431
• ":MARKer:X2Y2source" on page 433
• ":MARKer:Y1Position" on page 437
• ":MARKer:Y2Position" on page 438
• ":MARKer:YUNits" on page 440
NOTE
If the front-panel cursors are off or are set to Binary or Hex Mode, the marker position values
are not defined. Make sure to set :MARKer:MODE to MANual or WAVeform to put the cursors
in the front-panel Normal mode.

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English