Keysight Technologies InfiniiVision 3000T X Series User Manual

1265
Keysight InfiniiVision 3000T X-Series Oscilloscopes
Programmer's Guide
40 Synchronizing Acquisitions
Synchronization in the Programming Flow / 1266
Blocking Synchronization / 1267
Polling Synchronization With Timeout / 1268
Synchronizing with a Single-Shot Device Under Test (DUT) / 1270
Synchronization with an Averaging Acquisition / 1272
When remotely controlling an oscilloscope with programming commands, it is
often necessary to know when the oscilloscope has finished the previous operation
and is ready for the next command. The most common example is when an
acquisition is started using the :DIGitize, :RUN, or :SINGle commands. Before a
measurement result can be queried, the acquisition must complete. Too often
fixed delays are used to accomplish this wait, but fixed delays often use excessive
time or the time may not be long enough. A better solution is to use synchronous
commands and status to know when the oscilloscope is ready for the next request.

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English