Keysight Technologies InfiniiVision 3000T X Series - :FFT:OFFSet

:FFT Commands 17
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 353
:FFT:OFFSet
(see page 1276)
Command Syntax
:FFT:OFFSet <offset>
<offset> ::= the value at center screen in NR3 format.
The :FFT:OFFSet command specifies the FFT vertical value represented at center
screen.
If you set the offset to a value outside of the legal range, the offset value is
automatically set to the nearest legal value.
Query Syntax
:FFT:OFFSet?
The :FFT:OFFSet? query returns the current offset value for the FFT function.
Return Format
<offset><NL>
<offset> ::= the value at center screen in NR3 format.
See Also • ":FFT:AVERage:COUNt" on page 347
• ":FFT:CENTer" on page 348
• ":FFT:CLEar" on page 349
• ":FFT:DISPlay" on page 350
• ":FFT:DMODe" on page 351
• ":FFT:RANGe" on page 354
• ":FFT:REFerence" on page 355
• ":FFT:SCALe" on page 356
• ":FFT:SOURce1" on page 357
• ":FFT:SPAN" on page 358
• ":FFT:STARt" on page 359
• ":FFT:STOP" on page 360
• ":FFT:VTYPe" on page 361
• ":FFT:WINDow" on page 362
NOTE
The :FFT:OFFSet command is equivalent to the :FFT:REFerence command.