Keysight Technologies InfiniiVision 3000T X Series User Manual

560 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
24 :MTESt Commands
:MTESt:COUNt:FWAVeforms
(see page 1276)
Query Syntax
:MTESt:COUNt:FWAVeforms? [CHANnel<n>]
<n> ::= 1 to (# analog channels) in NR1 format
The :MTESt:COUNt:FWAVeforms? query returns the total number of failed
waveforms in the current mask test run. This count is for all regions and all
waveforms collected on the channel specified by the optional parameter or
collected on the currently specified source channel (:MTESt:SOURce) if there is no
parameter.
Return Format
<failed><NL>
<failed> ::= number of failed waveforms in NR1 format.
See Also • "Introduction to :MTESt Commands" on page 551
• ":MTESt:COUNt:WAVeforms" on page 563
• ":MTESt:COUNt:TIME" on page 562
• ":MTESt:COUNt:RESet" on page 561
• ":MTESt:SOURce" on page 581
Example Code • "Example Code" on page 551

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English