Keysight Technologies InfiniiVision 3000T X Series - :SAVE:FILename

672 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
28 :SAVE Commands
:SAVE:FILename
(see page 1276)
Command Syntax
:SAVE:FILename <base_name>
<base_name> ::= quoted ASCII string
The :SAVE:FILename command specifies the source for any SAVE operations.
Query Syntax
:SAVE:FILename?
The :SAVE:FILename? query returns the current SAVE filename.
Return Format
<base_name><NL>
<base_name> ::= quoted ASCII string
See Also • "Introduction to :SAVE Commands" on page 669
• ":SAVE:IMAGe[:STARt]" on page 673
• ":SAVE[:SETup[:STARt]]" on page 689
• ":SAVE:WAVeform[:STARt]" on page 690
• ":SAVE:PWD" on page 682
• ":RECall:FILename" on page 661
NOTE
This command specifies a file's base name only, without path information or an extension.