Keysight Technologies InfiniiVision 3000T X Series User Manual

:DIGital<d> Commands 13
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 309
:DIGital<d>:DISPlay
(see page 1276)
Command Syntax
:DIGital<d>:DISPlay <display>
<d> ::= 0 to (# digital channels - 1) in NR1 format
<display> ::= {{1 | ON} | {0 | OFF}}
The :DIGital<d>:DISPlay command turns digital display on or off for the specified
channel.
Query Syntax
:DIGital<d>:DISPlay?
The :DIGital<d>:DISPlay? query returns the current digital display setting for the
specified channel.
Return Format
<display><NL>
<display> ::= {0 | 1}
See Also • "Introduction to :DIGital<d> Commands" on page 308
• ":POD<n>:DISPlay" on page 585
• ":CHANnel<n>:DISPlay" on page 270
• ":VIEW" on page 230
• ":BLANk" on page 202
• ":STATus" on page 227
NOTE
This command is only valid for the MSO models.

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English