Keysight Technologies InfiniiVision 3000T X Series - Page 308

308 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
13 :DIGital<d> Commands
Introduction to
:DIGital<d>
Commands
<d> ::= 0 to (# digital channels - 1) in NR1 format
The DIGital subsystem commands control the viewing, labeling, and positioning of
digital channels. They also control threshold settings for groups of digital
channels, or pods.
Reporting the Setup
Use :DIGital<d>? to query setup information for the DIGital subsystem.
Return Format
The following is a sample response from the :DIGital0? query. In this case, the
query was issued following a *RST command.
:DIG0:DISP 0;THR +1.40E+00;LAB 'D0';POS +0
NOTE
These commands are only valid for the MSO models.