Keysight Technologies InfiniiVision 3000T X Series - :SBUS<n>:I2 S:TRIGger:AUDio

778 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
29 :SBUS<n> Commands
:SBUS<n>:I2S:TRIGger:AUDio
(see page 1276)
Command Syntax
:SBUS<n>:I2S:TRIGger:AUDio <audio_ch>
<audio_ch> ::= {RIGHt | LEFT | EITHer}
The :SBUS<n>:I2S:TRIGger:AUDio command specifies the audio channel to trigger
on:
• RIGHt — right channel.
• LEFT— left channel.
• EITHer — right or left channel.
Query Syntax
:SBUS<n>:I2S:TRIGger:AUDio?
The :SBUS<n>:I2S:TRIGger:AUDio? query returns the current audio channel for the
I2S trigger.
Return Format
<audio_ch><NL>
<audio_ch> ::= {RIGH | LEFT | EITH}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":SBUS<n>:I2S:TRIGger" on page 776