Keysight Technologies InfiniiVision 3000T X Series - :MEASure:RIPPle

:MEASure Power Commands 23
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 545
:MEASure:RIPPle
(see page 1276)
Command Syntax
:MEASure:RIPPle [<source>]
<source> ::= {CHANnel<n>| FUNCtion<m> | MATH<m> | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<m> ::= 1 to (# math functions) in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
The :MEASure:RIPPle command installs an output ripple measurement on screen.
The <source> parameter is the channel probing the output voltage. This source
can also be specified by the :MEASure:SOURce command.
Output ripple is: Vmax - Vmin.
Query Syntax
:MEASure:RIPPle? [<source>]
The :MEASure:RIPPle query returns the measured output ripple.
Return Format
<return_value><NL>
<return_value> ::= the output ripple value in NR3 format
See Also • ":MEASure:SOURce" on page 499
• ":POWer:RIPPle:APPLy" on page 623