Keysight Technologies InfiniiVision 3000T X Series User Manual

:SBUS<n> Commands 29
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 771
:SBUS<n>:I2S:CLOCk:SLOPe
(see page 1276)
Command Syntax
:SBUS<n>:I2S:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :SBUS<n>:I2S:CLOCk:SLOPe command specifies which edge of the I2S serial
clock signal clocks in data.
•NEGative — Falling edge.
• POSitive — Rising edge.
Query Syntax
:SBUS<n>:I2S:CLOCk:SLOPe?
The :SBUS<n>:I2S:CLOCk:SLOPe? query returns the current I2S clock slope
setting.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":SBUS<n>:I2S:ALIGnment" on page 769
• ":SBUS<n>:I2S:RWIDth" on page 772
• ":SBUS<n>:I2S:TWIDth" on page 784
• ":SBUS<n>:I2S:WSLow" on page 785

Keysight Technologies InfiniiVision 3000T X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000T X Series
Category	Test Equipment
Language	English