Keysight Technologies InfiniiVision 3000T X Series - :MTESt:LOAD

1218 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
37 Obsolete and Discontinued Commands
:MTESt:LOAD
(see page 1276)
Command Syntax
:MTESt:LOAD "<filename>"
The :MTESt:LOAD command loads the specified mask file.
The <filename> parameter is an MS-DOS compatible name of the file, a maximum
of 254 characters long (including the path name, if used).
See Also • "Introduction to :MTESt Commands" on page 551
• ":MTESt:AMASk:{SAVE | STORe}" on page 1215
NOTE
The :MTESt:LOAD command is obsolete and is provided for backward compatibility to previous
oscilloscopes. Use the :RECall:MASK[:STARt] command (see page 662) instead.