Keysight Technologies InfiniiVision 3000T X Series - :POWer:SIGNals:AUTosetup

624 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
26 :POWer Commands
:POWer:SIGNals:AUTosetup
(see page 1276)
Command Syntax
:POWer:SIGNals:AUTosetup <analysis>
<analysis> ::= {HARMonics | EFFiciency | RIPPle | MODulation | QUALity
| SLEW | SWITch | RDSVce}
The :POWer:SIGNals:AUTosetup command performs automated oscilloscope
setup for the signals in the specified type of power analysis.
See Also • ":POWer:HARMonics:DISPlay" on page 600
• ":POWer:EFFiciency:APPLy" on page 595
• ":POWer:RIPPle:APPLy" on page 623
• ":POWer:MODulation:APPLy" on page 611
• ":POWer:QUALity:APPLy" on page 622
• ":POWer:SLEW:APPLy" on page 643
• ":POWer:SWITch:APPLy" on page 645
• ":POWer:SIGNals:CYCLes:HARMonics" on page 625
• ":POWer:SIGNals:CYCLes:QUALity" on page 626
• ":POWer:SIGNals:DURation:EFFiciency" on page 627
• ":POWer:SIGNals:DURation:MODulation" on page 628
• ":POWer:SIGNals:DURation:RIPPle" on page 631
• ":POWer:SIGNals:IEXPected" on page 633
• ":POWer:SIGNals:OVERshoot" on page 634
• ":POWer:SIGNals:SOURce:CURRent<i>" on page 641
• ":POWer:SIGNals:SOURce:VOLTage<i>" on page 642