Keysight Technologies InfiniiVision 3000T X Series - :WGEN<w>:OUTPut

1156 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
35 :WGEN<w> Commands
:WGEN<w>:OUTPut
(see page 1276)
Command Syntax
:WGEN<w>:OUTPut <on_off>
<w> ::= 1 or 2 in NR1 format
<on_off> ::= {{1 | ON} | {0 | OFF}
The :WGEN<w>:OUTPut command specifies whether the waveform generator
signal output is ON (1) or OFF (0).
Query Syntax
:WGEN<w>:OUTPut?
The :WGEN<w>:OUTPut? query returns the current state of the waveform
generator output setting.
Return Format
<on_off><NL>
<on_off> ::= {1 | 0}
See Also • "Introduction to :WGEN<w> Commands" on page 1128