Keysight Technologies InfiniiVision 3000T X Series - :MARKer:DYDX

428 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
21 :MARKer Commands
:MARKer:DYDX
(see page 1276)
Query Syntax
:MARKer:DYDX?
The MARKer:DYDX? query returns the cursor ∆Y/∆X value.
X cursor units are set by the :MARKer:XUNits command.
Return Format
<value><NL>
<value> ::= •Y/•X value in NR3 format.
See Also • "Introduction to :MARKer Commands" on page 426
• ":MARKer:MODE" on page 429
• ":MARKer:X1Position" on page 430
• ":MARKer:X2Position" on page 432
• ":MARKer:X1Y1source" on page 431
• ":MARKer:X2Y2source" on page 433
• ":MARKer:XUNits" on page 435
NOTE
If the front-panel cursors are off, the marker position values are not defined. Make sure to set
:MARKer:MODE to MANual or WAVeform to put the cursors in the front-panel Normal mode.